Special Design for 1/10th, 1/8th Crawlers
The reliable hardware combined with powerful software (features an array of
programmable parameters like start force, drag brake rate, and etc.)
creates an ideal power solution to 1/10th, 1/8th rock crawlers.
Best For Crawler
Adjustable PWM Frequency & Advanced DEO/Freewheeling Technology
The adjustable PWM frequency combined with advanced DEO/freewheeling technology
guarantees users great throttle linearity and driving feel.
Adjustable PWM Frequency
Applicable to All Weather Conditions
The waterproof and dust-proof design allows the WP-Crawler-Brushed
to be used in all weather conditions without any issue of
damage caused to the ESC from water or debris.
Applicable to All
Excellent Braking Performance
Hobbywing's innovative, fine-tunable drag brake rate and adjustable drag brake and brake force
greatly improve the brag brake and allow users to have the excellent braking performance.
Super Internal BEC
The built-in switch mode BEC with a maximum output of 6A and voltage
adjustable between 6V and 7.4V allows the use of various standard servos,
high voltage servos and other peripherals.
Super Internal BEC
15 Programmable Parameters
The WP-Crawler-Brushed, which features 15 programmable parameter items,
is applicable to various vehicles and tracks.
Separate Programming/Fan Port
The separate PRG/FAN port on the ESC can power an external fan to maximize cooling
performance or connect the ESC to a LED program box for ESC programming.
Separate Programming Port
A LED Program Box is Included
A standard, dedicated LED program box (included in the box) allows users to
program the WP-Crawler-Brushed easily.
LED Program Box
Wires & Connectors
ESC Programing via
Size & Weight
Because the ESC didn't detect any correct throttle signals then, so please check the following items:
1)1)If the throttle control cable has been plugged in the improper channel on the receiver.
2)2)If the throttle control cable has been reversely plugged in the TH channel on the receiver.
3)3)The neutral position has been set improperly, please reset the throttle range.
1)1)The motor ran in reverse. In that case, you only need to swap two wire connections between the ESC and motor.
2)2)You incorrectly set the throttle direction on the transmitter, so please adjust the TH direction from "OR" to "REV" or from "REV" to "NOR".
The Red LED flashes a single flash that repeats indicating the low-voltage cutoff protection is activated; please change the battery pack.
The Green LED flashes a single flash that repeats indicating the ESC thermal protection is activated; you need to cool the ESC down before using it again.
1)1)Improper connection. The programming port of this ESC is the Programming port; you cannot connect your ESC to the LCD program box via the throttle control cable.