QuicRun 2435 G2_Car Systems_HOBBYWING TECHNOLOGY CO., LTD.

QuicRun 2435 G2

Overview
Specifications
Support
Accessories
Details

Great Construction

The use of a heat-resistant magnet attached steel case and double insulated windings,
high precision bearings, and rotor with a strong structure guarantees outstanding
performance and super durability.

Great Construction

Cost-effective

The QUICRUN-2435 is an inexpensive motor but applicable
to 1/16^th & 1/18^th scale vehicles.

Cost-effective

High Efficiency

The output performance of this motor has an efficiency of up to 80%.
In the same load condition, QUICRUN 2435 has the higher efficiency but lower temperature
than other 2435 motors.

High Efficiency

Dustproof Design

The dustproof design implemented at the load end of the motor makes this
QUICRUN 2435 motor applicable for monster trucks, buggies.

Dustproof Design

Plug and Play

Pre-soldered with high-quality gold connectors on motor leads,
the QUICRUN 2435 motor is a plug and play.

Plug and Play

Wide Application

The QUICRUN 2435 is applicable to various 1/16^th & 1/18^th scale vehicles,
especially buggies & monster trucks.

Wide Application

Possible Causes	Solutions
1. In sensored mode, the motor-to ESC (A/B/C) wires was connected wrongly.	1. The motor-to-ESC wires must be connected in this way: A-A, B-B, C-C.
2. The coil is damaged.	2. Reture the motor to facotry for repair or replacement.

Possible Causes	Solutions
1. The motor rotor is broken or demagnetized.	1. Reture the motor to facotry for repair or replacement.
2.The ESC is damaged.	2. Reture the ESC to facotry for repair.
3. Poor connection(s) caused by the oxidization, desoldering of the output end of the motor.	3. Check if poor connection exists, re-solder it yourself or return it to factory for repair if necessary.

Possible Causes	Solutions
1. The motor works in high tempature condition for a long time.	1. The external temperature of the motor should be lower than 100℃ in use.
2. The gear ratio is too big (the pinion is too big or the spur is too small).	2. Lower down the gear ratio (change another pinion with fewer teeth or change another spur with more teeth).

The motor stuttered and it couldn't spin nomrally.

The motor couldn't start.

The motor rotor is broken or demagnetized